Set of 20 Black Replacement Handle Arm Assemblies


Set of 20 entire long cutting arm assemblies with black steel C-shaped metal bar, black handle and long wire.
Includes 20 long black cutting arm (C-shaped metal bar), 20 black plastic handles with aluminum dowel, 20 long cutting wires, and 20 set screws.

Recommended configuration and assembly instructions to create your own cheese slicer board:

  1. Choose material (wood or stone) 1/2 to 1 inch thick, at least 5-3/4 inches deep, and 7 inches wide
  2. Mark a spot 1/4 inch from surface and 5 inches from the front edge of the board
  3. At the spot marked in step 2, drill 1/4 to 17/64 inch hole drilled parallel to cutting surface, 3-7/8 inches deep; A 1/4 inch hole will give a tighter fit for the cutting arm; a 17/64 inch hole will give a looser fit
  4. Cut an angled groove 1/16 - 3/32 inch wide cutting groove, 3 inches from right edge,  5/8 inch deep in back, 1/16 inch deep in front; groove must fully intersect the hole drilled in step 3
  5. Insert wire into the groove so that one loop is located where the hole is drilled
  6. Insert the longer end of the cutting arm into the hole, passing it through the loop in the wire
  7. Turn the handle away from the board to tighten the wire
  8. Tighten the set screw into the metal bar
  9. Gently work bar either into or out of the base until the wires is aligned with the cutting slot

 Make your own cheese slicer


  • Set of 20 black assemblies


Quantity Set of 20

Other Images

All Prices in US Dollars

Order Information

Item Number



Accept Credit Cards
Cheeseslicing, LLC BBB Business Review Nextag Seller

Contact our Customer Service Department ·